Muratec MFX-3070 Guide de l'utilisateur télécharger pdf (Page 89)

•

telephone. If you do not answer, your machine will switch back to fax mode to allow

the calling party to manually send a fax.

Refer to “Reception Mode” on page 68 for details on enabling Tel/Fax mode.

TAD interface

Telephone Answering Device Mode (TAD): Use this mode if you want the machine and

telephone answering machine to share the same phone line. Like Telephone/fax

mode, the TAD mode detects whether an incoming call is fax or voice call. Refer to

“Adding a telephone handset” on page 68 for more information.

To set up TAD mode:

1. Using the Down arrow key, scroll to Menu and press Enter.

2. Using the Down arrow key, scroll to Admin Setup and press Enter.

3. Using the arrow keys and on-screen keypad, enter the Administrator password.

Highlight Done and press Enter.

4. Using the Down arrow key, scroll to Fax Setup and press Enter.

5. Using the Down arrow key, scroll to Basic Setup and press Enter.

6. Using the Down arrow key, scroll to TAD Mode and press Enter.

7. Select the appropriate setting; Type1, Type2, Type3.

8. Press the Left arrow key to exit the menu.

Refer to “Reception Mode” on page 68 for details on enabling TAD mode.

DRD interface

Distinctive Ring Detection Mode (DRD): This mode is programmed for the fax to

answer only on a distinctive ring. You can have a single phone line to have two

numbers with distinct rings, one for regular phone calls and one for fax. If the phone

line is in use, and there is an incoming fax, the sender will receive a busy signal.

To set up DRD mode:

1. Using the Down arrow key, scroll to Menu and press Enter.

2. Using the Down arrow key, scroll to Admin Setup and press Enter.

3. Using the arrow keys and on-screen keypad, enter the Administrator password.

Highlight Done and press Enter.

4. Using the Down arrow key, scroll to Fax Setup and press Enter.

5. Using the Down arrow key, scroll to Basic Setup and press Enter.

6. Using the Down arrow key, scroll to DRD Type and press Enter.

7. Select the appropriate setting; Type1, Type2, Type3, Type4.

8. Press the Left arrow key to exit the menu.

Refer to “Reception Mode” on page 68 for details on enabling DRD mode.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 178 179

Pas de commentaire

Muratec MFX-3070 Guide de l'utilisateur Page 89