Muratec F-565 Spécifications télécharger pdf (Page 362)

5-72

Printer registration (side)

Test pattern H

Adjust so that width A on the test pattern Checkered output falls within the following range.

Standard Adjustment Tool Setting Range

10 ± 1.8 (mm) Machine parameter: 100, 140, 160

–12.8 to 12.7 (mm)

(0.6773 mm step)

Adjustment procedure

1. Load legal (for USA version) or A4 (for GBR version) size paper to the cassette or tray you want

to adjust.

2. Use the Unique Switch 52 to adjust the printing margin to 0 mm. (bit 0, 10)

3. Printout the test pattern “Ladder”. (Press <Setting> , <*> , <0> , <9> , [Test Pattern Print] ,

[Ladder].)

4. Check width A on the test pattern Ladder meets the speciﬁcations.

If width A falls outside the speciﬁed range, perform following steps to make the adjustment.

5. To use the “Printer registration mode,” press <Setting> , <*> , <4> , <3> and then select the cas-

sette.

6. Select “Vertical Regi ”, and then adjust the “Vertical Registration”.

If the width A is shorter than the standard, increase value.

If the width A is longer than the standard, decrease value.

7. After you have ﬁnished the adjustment, you must reenter the setting of Unique Switch 52, you

changed in step 2.

Important: The setting you have entered in Printer registration mode is reﬂected in the following

Machine parameters.

Cassette1 : Machine parameter 100, 140, 160

Cassette2 : Machine parameter 101, 141, 161

Bypass Tray : Machine parameter 107, 147, 167

Duplex Unit: Machine parameter 108, 148, 168

1 2 ... 357 358 359 360 361 362 363 364 365 366 367 ... 382 383

Pas de commentaire

Muratec F-565 Spécifications Page 362