Muratec MFX-C2700 Manuel d'utilisateur télécharger pdf (Page 126)

Troubleshooting > 126

8. Holding the image drum assembly by its handles, lower it into place in the machine,

locating the pegs at the sides into their slots in the sides of the printer cavity.

9. Lower the top cover but do not press down to latch it closed yet. This will protect the

drum from excessive exposure to room lighting while you check the remaining areas

for jammed sheets.

10. Open the rear exit tray (h) and check for a sheet of paper in the rear path area (i).

> Pull out any sheets found in this area.

> If the sheet is low down in this area and difficult to remove, it is probably still

gripped by the fuser. In this case raise the top cover, reach around and press

down on the fuser pressure release lever (d).

11. If you are not using the rear exit tray, close it once any paper has been removed

from this area.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 165 166

Pas de commentaire

Muratec MFX-C2700 Manuel d'utilisateur Page 126